1128 Firmware

v5.1.2
Fixed issue with recent silicon causing charge cable to falsely enumerate USB, thus disconnecting BT

V5.1.1

Fixed bug with -ql Query Select parameters on RF commands

V5.0.9

Fixed bug which could stop switch working
Added new option for HID .hs/.hd -td pri  -  send only ASCII printables
Added some regulatory testing commands (factory use only)
Internal code optimisation
Improved some minor bugs

V5.0.4

Added support for power handles
Better internal power control for some regions
Added .sr Show Region command and power level reporting
Added .tm -hu on|off to show hundreths of seconds in timestamps
Internal code optimisation
Improved some minor bugs

V5.0.5

Internal changes

V4.5.5

Added support for regions: Japan, Vietnam, Chile, Singapore (Low power)

4.5.2:

Added substrings to HID output – new parameters to .hd/.hs commands

Document detailing the firmware version history of the 1128 Bluetooth^® UHF RFID Reader. Older firmware versions can be found in the 1128 Firmware Page

The document describes the process of updating firmware to a TSL ASCII Protocol Reader.

v5.1.2
Fixed issue with recent silicon causing charge cable to falsely enumerate USB, thus disconnecting BT

V5.1.1

Fixed bug with -ql Query Select parameters on RF commands

V5.0.9

Fixed bug which could stop switch working
Added new option for HID .hs/.hd -td pri  -  send only ASCII printables
Added some regulatory testing commands (factory use only)
Internal code optimisation
Improved some minor bugs

V5.0.4

Added support for power handles
Better internal power control for some regions
Added .sr Show Region command and power level reporting
Added .tm -hu on|off to show hundreths of seconds in timestamps
Internal code optimisation
Improved some minor bugs

V5.0.5

Internal changes

V4.5.5

Added support for regions: Japan, Vietnam, Chile, Singapore (Low power)

4.5.1:

Fixed long-standing bug where incorrectly formatted AUTO.TXT could cause reader to hang

4.5.0:

Fixed issue with IX: response
Improved backoff algorithm to reduce heat with long inventories.
Added new .sh command for HID over SPP connections

***Please Note****  TSL PC Firmware Downloader v1.13 or higher is required to load this firmware. Please also see Application Note – Downloading Firmware and 1128 Firmware History.

4.4.1:

Added reset of Bluetooth reconnect mode on .bt -m

4.4.0:

Added extra startup beeps to indicate HID & HII modes.
Improved scan engine startup time.
Fixed charging issue with totally flat battery

***Please Note****  TSL PC Firmware Downloader v1.13 or higher is required to load this firmware. Please also see Application Note – Downloading Firmware and 1128 Firmware History.
 

4.3.0:

Reader can remember who it was last connected to and attempt reconnect at power-on (currently iOS devices only).

New options on sleep (.sl) command to enable/disable.

4.2.8:

Fixed issue where .wr command used parameters from the .ws command for Alert, CRC, RSSI, PC.

.hd -x now resets its own parameters not that of the .hs command.

Apple HID mode is now correctly reported (as hii) in the .bt -p response.

***Please Note****  TSL PC Firmware Downloader v1.13 or higher is required to load this firmware. Please also see Application Note – Downloading Firmware and 1128 Firmware History.